Schoeps CMC 1 K, LemoSD, Microphone Amplifier

€969.60
per piece
Tax included

The CMC 1 is our new, small Colette microphone amplifier, about one-third the length and 53% lighter than the CMC 6.


Accessories for this and other products can be found in the category "Accessories".

Quantity
on order, 4-6 weeks delivery time

The CMC 1 is our new, small Colette microphone amplifier, about one-third the length and 53% lighter than the CMC 6.

 It is compatible with all components of the Colette system and can be used in place of the CMC 6 without compromise, for all applications in which the size and weight of the microphone play a role.

At SCHOEPS, “uncompromising miniaturization” means that the electrical characteristics of the CMC 1 are equal to, or even better than, those of the CMC 6. Through modern electronic design, these outstanding electrical properties have been achieved.

 

ORDER NUMBER:   No. 132016 CMC 1 K, premanentely attached cable (0,5m Kabel, Lemo-3pin Sound Devices), incl. SGC, Premium Case

Features:

·         Complete alternative to the renowned CMC 6

·         Fully compatible with all existing MK capsules and Colette active accessories such as the CUT 60 and RC tubes

·         Suitable mounting accessories are already available, such as the CINELA E-OSIX-CMC1U and the Rycote INV-6 elastic suspensions.

·         high maximum SPL: 135 dB-SPL with the MK 4 (0.5% THD or less)

·         very low current consumption: 2.0 mA at 48 Volts

·         operates on 48 V or 12 V phantom power, reliable operation even if powering is somewhat marginal

·         very high immunity from RF interference with the SCHOEPS RFI Shield; high immunity to cable-induced hum and other interference (field tested with Audio Limited A 10, etc.)

·         flat frequency response

·         very low distortion constant output impedance across the audio frequency range

·         balanced, direct-coupled, class-A output circuit

·         output is filtered in the ultrasonic range to prevent interference, e.g. from camera autofocus

TECHNICAL SPECIFICATIONS:

Frequency range:   20 Hz-20 kHz

Sensitivity:   see corresponding capsule

Maximum output voltage:   1,8 V (5 dbV) with 1  load

Maximum sound pressure level (THD < 0.5 %):   135 dB-SPL (P48) with MK 4

   131 dB-SPL (P12) with MK 4

Low cut filter:   20 Hz, 12 dB/oct

Output impedance:   50 Ω +/- 1 Ω (8 Hz - 50 kHz)

Minimum recommended load impedance:   

Common mode rejection ratio (at 1 kHz):   > 55 dB

Maximum cable length               :   > 400 m / ~1300 ft

SCHOEPS RFI Shield:   Yes

Powering standard / Valid range:   P48 / 30-52 V

       P12 / 11-13 V

Current consumption:   2 mA (P48)

 3 mA (P12)

Output:   XLR-3M, analog, 1 channel

                Length:   36 mm / ~1.4"

Diameter:   20 mm / 0.8"

Weight                :   36 g / 1.3 oz

Surface finish:   matte gray

custom color:   nickel, chromagreen